澳门在线威尼斯官方 > 电脑数据库 > 威尼斯澳门在线MySQL E凯雷德ROEscort Got an error re

原标题:威尼斯澳门在线MySQL E凯雷德ROEscort Got an error re

浏览次数:145 时间:2019-09-17

介绍

经常会在错误日志中看到这个报错,首先我们可以从show GLOBAL status like '%Aborte%';里面看看两种错误连接的数量,以下是复制官方文档的解释。   

 

MySQL ERROR Got an error reading communication packets,communicationerror

Aborted_connects 

If a client is unable even to connect, the server increments the Aborted_connects status variable. Unsuccessful connection attempts can occur for the following reasons:

  • A client attempts to access a database but has no privileges for it.

  • A client uses an incorrect password.

  • 威尼斯澳门在线 ,A connection packet does not contain the right information.

  • It takes more than connect_timeout seconds to obtain a connect packet. See Section 5.1.4, “Server System Variables”.

If these kinds of things happen, it might indicate that someone is trying to break into your server! If the general query log is enabled, messages for these types of problems are logged to it.

 

对于Aborted_connects错误的大概原因有:

1.客户端连接一个没有授权的数据库

2.密码错误

3.连接包信息错误

4.连接超时(默认10s)

介绍

经常会在错误日志中看到这个报错,首先我们可以从show GLOBAL status like '%Aborte%';里面看看两种错误连接的数量,以下是复制官方文档的解释。   

 

Aborted_clients

If a client successfully connects but later disconnects improperly or is terminated, the server increments the Aborted_clients status variable, and logs an Aborted connection message to the error log. The cause can be any of the following:

  • The client program did not call mysql_close() before exiting.

  • The client had been sleeping more than wait_timeout or interactive_timeout seconds without issuing any requests to the server. See Section 5.1.4, “Server System Variables”.

  • The client program ended abruptly in the middle of a data transfer.

Other reasons for problems with aborted connections or aborted clients:

  • The max_allowed_packet variable value is too small or queries require more memory than you have allocated for mysqld. See Section B.5.2.10, “Packet Too Large”.

  • Use of Ethernet protocol with Linux, both half and full duplex. Some Linux Ethernet drivers have this bug. You should test for this bug by transferring a huge file using FTP between the client and server machines. If a transfer goes in burst-pause-burst-pause mode, you are experiencing a Linux duplex syndrome. Switch the duplex mode for both your network card and hub/switch to either full duplex or to half duplex and test the results to determine the best setting.

  • A problem with the thread library that causes interrupts on reads.

  • Badly configured TCP/IP.

  • Faulty Ethernets, hubs, switches, cables, and so forth. This can be diagnosed properly only by replacing hardware.

 

对于 Aborted_clients的原因大概有

1.客户端没有执行mysql_close()关闭

2.由于连接一直没有关闭导致时间超过wait_timeout or interactive_timeout这两个变量的值(这两个变量的超时时间是8小时)

3.客户端在程序执行过程中结束

4.max_allowed_packet包设的过小

5.网络原因

6.线程bug等

Aborted_connects 

If a client is unable even to connect, the server increments the Aborted_connects status variable. Unsuccessful connection attempts can occur for the following reasons:

  • A client attempts to access a database but has no privileges for it.

  • A client uses an incorrect password.

  • A connection packet does not contain the right information.

  • It takes more than connect_timeout seconds to obtain a connect packet. See Section 5.1.4, “Server System Variables”.

If these kinds of things happen, it might indicate that someone is trying to break into your server! If the general query log is enabled, messages for these types of problems are logged to it.

 

对于Aborted_connects错误的大概原因有:客户端连接一个没有授权的数据库、密码错误、连接包信息错误、连接超时(默认10s)

本文由澳门在线威尼斯官方发布于电脑数据库,转载请注明出处:威尼斯澳门在线MySQL E凯雷德ROEscort Got an error re

关键词:

上一篇:没有了

下一篇:MEB的备份恢复生机